Low-cost powder mixer v-mixer v-type dry powder blender has a unique mixing barrel structure. High mixing efficiency, no dead ends, the barrel, and bracket can be made of Q235 carbon steel, or the barrel SUS304 stainless steel, and the barrel bracket is all made of SUS304. For special material cylinders, plastic cylinders can be used, mainly for materials that cannot be in contact with metals and strong corrosive materials. The inner and outer walls are polished, the appearance is beautiful, the mixing is uniform, and the use is wide. Comply with GMP standard, and can be equipped with compulsory agitator according to user requirements.
Low-cost powder mixer v-mixer v-type dry powder blender the mixing barrel has a unique structure, uniform mixing, high efficiency, and no material accumulation. The whole machine has a simple structure and easy operation. The outer surface and the material contact part are made of high-quality stainless steel, beautiful in appearance, easy to maintain and clean. One end of the machine is equipped with a motor and a reducer. The power of the motor is transmitted to the reducer through the belt, and the reducer is transmitted to the V-shaped barrel through the Union. Make the V-shaped barrel run continuously to drive the materials in the barrel to mix up, down, left, and right in the barrel.
Low-cost powder mixer v-mixer v-type dry powder blender adopts manual feeding and closed disc valve discharging structure, which can implement the dust-free operation, and at the same time, the material is mixed without mechanical extrusion and strong friction, which can keep the material particles Intact, the mixing barrel of this machine is made of stainless steel, without any pollution to the mixture. In addition, the machine is also equipped with a timing device to control the mixing time of materials.
Low-cost powder mixer v-mixer v-type dry powder blender The length of two cylinders is not equal, forming asymmetric. When the mixer rotates, due to the different potential energy of the material from decomposition to combination, a lateral force is generated to push the material to communicate horizontally. When the materials are combined to decomposed, there is a horizontal force due to the different planes of the materials, which pushes the materials to communicate horizontally, and then rotates the horizontal force to make about 25% of the materials flow from one cylinder to the other. , The decomposition and combination are carried out intersecting, so that the materials can achieve very uniform mixing. When the materials are mixed, there is no mechanical extrusion and strong abrasion, which can keep the material particles intact, easy to discharge, and easy to clean when changing products. The mixing is operated in a closed state, providing good conditions for dust-free operation.